empire prophecy PROBLEM!!! plaseee help

[paintmaster22]

my prophecy works fine whenever there is no paintballs in it....but when i put a pod of paint into it, the bottom motor will NOT SPIN....the rip drive only spins the top part of the motor. whenever i yell into the loader to make it feed, the motor kind of twitches but doesnt feed any paint??? im very confused, please help

if u can, please pm me on my youtube account because im on youtube almost everyday

[Simon]

It sounds like it might not be assembled properly, and one part of the shells or floor is sticking into the feedtray and stopping the balls from feeding.

Put just a few balls into it and see if you can see where they are catching.

[Raadio]

As a side note, about 99% of all prophecy problems I've encountered stem from that one problem. It's not assembled properly. All it takes is one tab and it throws off the entire loader.

[JBaller]

Yeah, Simon cleared it up pretty well..

ITs that one stem piece when assembled wrong throws off everything. Just that one piece, take a look at Simon's re-assembly videos.



-JBaller

[paintmaster22]

thanks guys.....about a day after i started this thread i gt it working, then i went to play yesturday, and it completely failed on me and had to use my cousins rotor

im sending into empire paintball tommorow